PDA

View Full Version : Player spawns at position 0 0 0 when an info_player_spawn already exsits!


mitterdoo
02-04-2011, 09:58 PM
When I compile my level with an EXISTING INFO_PLAYER_SPAWN, the player spawns at the position on all axes, 0. I really need help on this! All of my other maps' spawns work perfectly, but this one doesn't!

caesar
02-05-2011, 09:34 AM
check off the hitbox off the spawn player not is touching any walls or ceilings/brushes.

Vilkata
02-05-2011, 11:36 AM
As the previous poster mentioned, typically this is caused by the entity touching the ground. If you're in the editor, the graphic of the guy should be hovering above the ground just a little. If you pushed it down so the feet were exactly even with the floor, then it's too low. Move it back up just a tad and you should be fine.